Our Design

Design 1 Design 2
Image 01 Image 01
Every section is supported by two parallel metal sections. The pin at each end rests in the leg support. Every section has two legs at each end holding the parallel metal supports in place. The holes are where the pins are set to keep the sections in place.
Design 3 Design 4
Image 01 Image 01
The legs are designed to adjust so the pier will be completely level at all points. The sections are built out of beautiful cedar wood. All of the screws are entered from underneath the pier, leaving each section with a clean finish.
Design 5 Design 6
Image 01 Image 01
The wood sections are then placed in the two parallel support sections. An under view of the pier when the wood sections are placed on top of the parallel metal sections that are connected to the legs.

Classic Piers will install your existing pier at a convenient time for you! Contact us for more details!